1: Setting the Clock
A: Press and hold the “OK Key until the clock icon lights up and the hours begin to flash.
B: Adjust the hour up or down with the + and – arrows. Be sure that you use 24hour, AKA military time.
C: Next, press OK to proceed to the minutes, and set the correct minute with the + or – buttons.
D: You can press “ESC” to save and exit the programming menu, or press “OK to move on to setting your lights daily program.
2:Setting up a Daily Program
A: Press and hold the “OK” key to enter the programming menu. Press OK 2x to skip through the clock settings if the time is already set.
B: Set the hour for your lights on time, adjust this using the + or – buttons, then press OK to adjust the minute settings. This is the time you want your light to come on, so all channels should be set to 0. If you want moonlights during the night we suggest setting Channel B to 1-2% for ambient moonlighting at night. C: Press OK to move on to setting Timer Slot 2. This is your peak time, so we recommend putting the time in the middle between your on and off time.
D: Press OK after setting the time to proceed to setting Channel A. Enter a value with the +/- arrows, then press OK to proceed to Channel B, and repeat again for Channel C.
E: Set timer slot 3. This is the time you want your light to shut OFF, so all channels should be set to 0. If you want moolights during the night we suggest setting Channel B to 1-2% for ambient moonlighting at night. F: Press ESC when finished to exit the programming menu and save your settings.
instruction+sheet+Aqua+Knight+V2-pdf.pdf
1. Press and hold + or – to quickly scroll up or down through number settings.
2. Press and hold “OK” and “-” at the same time to return to the previous menu. This can help if you want to go back and edit a channel without scrolling all the way through the menu again.
3. In the setting mode, the indicator light corresponding to each operation will be highlighted, and the brightness of the lamp will change according to the settings on-screen. This provides a live preview of the lights operation.
Warranty Registration
Reef Breeders LLC Guarentees this product to be free of manufacturer’s defects for 24 months after the original purchase date. All Reef Nano LEDs must be registered within 60 days of receiving the item to qualify for warranty service.
To register your product please visit: www.reefbreeders.com/warranty-registration/
Please note that our warranty does not cover damage due to improper installation, lack of ventillation, excess dust build up, contact with water, salt creep, power surges, etc. Please read our warranty policy in its entirety prior to unboxing or installing this product. Our full warranty policy can be found at www.reefbreeders/com/warranty-policy/